Reference Guide

Example of Copying a File to current File System

Dell#copy tftp://10.16.127.35/mashutosh/dv-maa-s4810-test nfsmount://

Destination file name [dv-maa-s4810-test]:

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!.!

44250499 bytes successfully copied

Dell#

Dell#copy ftp://10.16.127.35 nfsmount:

Source file name []: test.c

User name to login remote host: mashutosh

Example of Logging in to Copy from NFS Mount

Dell#copy nfsmount:///test flash:

Destination file name [test]: test2

5592 bytes successfully copied

Dell#

Dell#copy nfsmount:///test.txt ftp://10.16.127.35

Destination file name [test.txt]:

User name to login remote host: mashutosh

Password to login remote host:

Example of Copying to NFS Mount

Dell#copy flash://test.txt nfsmount:///

Destination file name [test.txt]:

15 bytes successfully copied

Dell#copy flash://ashu/capture.txt.pcap nfsmount:///

Destination file name [test.txt]:

15 bytes successfully copied

Dell#copy flash://ashu/capture.txt.pcap nfsmount:///ashutosh/snoop.pcap

24 bytes successfully copied

Dell#

Dell#copy tftp://10.16.127.35/mashutosh/dv-maa-s4810-test ?

flash: Copy to local file system ([flash://]filepath)

nfsmount: Copy to nfs mount file system (nfsmount:///filepath)

running-config remote host:

Destination file name [test.c]:

225 bytes successfully copied

Dell#

Saving the Running-Configuration

The running-configuration contains the current system configuration. Dell Networking recommends

coping your running-configuration to the startup-configuration.

The system uses the startup-configuration during boot-up to configure the system. The startup-

configuration is stored in the internal flash on the IOM by default, but you can save the startup-

configuration to a USB flash device or on a remote server.

NOTE: The commands in this section follow the same format as those in Copying Files to and from

the System but use the filenames startup-configuration and running-configuration. These

commands assume that current directory is the internal flash, which is the system default.

• Save the running-configuration to the startup-configuration on the internal flash.

Getting Started