Reference Guide

To tag frames leaving an interface in Layer 2 mode, assign that interface to a port-based VLAN to tag it

with that VLAN ID.

1. Access the INTERFACE VLAN mode of the VLAN to which you want to assign the interface.

CONFIGURATION mode

interface vlan vlan-id

2. Enable an interface to include the IEEE 802.1Q tag header.

INTERFACE mode

tagged interface

3. To move untagged interfaces from the default VLAN to another VLAN, use the untagged command.

Access the INTERFACE VLAN mode of the VLAN to which you want to assign the interface.

CONFIGURATION mode

interface vlan vlan-id

4. Configure an interface as untagged. This command is available only in VLAN interfaces.

INTERFACE mode

untagged interface

Assigning an IP Address to a VLAN

VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to communicate, assign an IP

address to the VLANs to route traffic between the two interfaces. The shutdown command in

INTERFACE mode does not affect Layer 2 traffic on the interface.

NOTE: You cannot assign an IP address to the default VLAN, which, by default, is VLAN1. To assign

another VLAN ID to the default VLAN, use the default vlan-id vlan-id command.

• Configure an IP address and mask on the interface.

INTERFACE mode

ip address ip-address mask [secondary]

Connect the S5000 to the Network

After you have completed the hardware installation and software configuration for the S5000 system, you

can connect to your company network by following your company’s cabling requirements.

Configure File Management

You can store on and access files from various storage media. Rename, delete, and copy files on the

system from the EXEC Privilege mode.

NOTE: Using flash memory cards in the system that have not been approved by Dell Networking

can cause unexpected system behavior, including a reboot.

Getting Started