Reference Guide

L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: S5000 FC CPU
CPLD: S5000 CPLD Rev 41
I2C: ready
SPI: ready
DRAM: Detected RDIMM VL33B5263F-K9S
Detected 4096 MB of memory
This U-Boot only supports < 4G of DDR
You could rebuild it with CONFIG_PHYS_64BIT
2 GiB (DDR3, 64-bit, CL=6, ECC off)
--More--
Configuring the Fibre Channel Port Group in Passthrough
Ethernet Mode
To configure a Fibre Channel port group to enable Passthrough Ethernet mode, use the following
commands.
1. Configure a Fibre Channel port group to enable Passthrough Ethernet mode.
CONFIGURATION mode
stack-unit unit-number port-group number portmode ethernet
2. Change the Fibre Channel mode.
no stack-unit unit-number port-group number portmode ethernet
CONFIGURATION mode
Examples of Configuring the Fibre Channel Port Group
The following example shows the stack-unit port-group portmode ethernet command.
Dell(conf)#stack-unit 0 port-group 0 portmode ethernet
Changing port mode on slot 0 port-group 0 will make interface configs of 0 and
1 obsolete after a save and
reload.
[confirm yes/no]:yes
Please save and reload for the changes to take effect.
Dell(conf)#
The following example shows the no stack-unit port-group portmode ethernet command.
Dell(conf)#no stack-unit 0 port-group 0 portmode ethernet
Changing port mode on slot 0 port-group 0 will make interface configs of 0 and
1 obsolete after a save and
reload.
[confirm yes/no]:yes
Please save and reload for the changes to take effect.
Dell(conf)#
Displaying Fibre Channel Port Group Mode Information
To display the Fibre Channel Port-Group mode information, use the following show command.
Example of the show system stack-unit Command
Dell#show system stack-unit 0 port-group portmode
PortGroupId Ports Mode(Curr Boot) Mode(Next Boot)
0 0,1 FC FC
384
Fibre Channel Interface