Reference Guide

To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of a command; for
example, no feature fip-snooping or no fip-snooping enable.
Displaying FIP Snooping Information
To display information on FIP snooping, use the following show commands.
Table 24. Displaying FIP Snooping Information
Command Output
show fip-snooping sessions [interface
vlan vlan-id]
Displays information on FIP-snooped sessions on
all VLANs or a specified VLAN, including the ENode
interface and MAC address, the FCF interface and
MAC address, VLAN ID, FCoE MAC address and
FCoE session ID number (FC-ID), worldwide node
name (WWNN) and the worldwide port name
(WWPN).
show fip-snooping config
Displays the FIP snooping status and configured
FC-MAP values.
show fip-snooping enode [enode-mac-
address]
Displays information on the ENodes in FIP-
snooped sessions, including the ENode interface
and MAC address, FCF MAC address, VLAN ID and
FC-ID.
show fip-snooping fcf [
fcf-mac-address]
Displays information on the FCFs in FIP-snooped
sessions, including the FCF interface and MAC
address, FCF interface, VLAN ID, FC-MAP value,
FKA advertisement period, and number of ENodes
connected.
clear fip-snooping database interface
vlan
vlan-id {fcoe-mac-address | enode-
mac-address | fcf-mac-address}
Clears FIP snooping information on a VLAN for a
specified FCoE MAC address, ENode MAC address,
or FCF MAC address, and removes the
corresponding ACLs FIP snooping generates.
show fip-snooping statistics [interface
vlan
vlan-id| interface port-type port/
slot | interface port-channel port-
channel-number
]
Displays statistics on the FIP packets snooped on
all interfaces, including VLANs, physical ports, and
port channels.
clear fip-snooping statistics
[interface vlan vlan-id | interface
port-type port/slot | interface port-
channel
port-channel-number]
Clears the statistics on the FIP packets snooped on
all VLANs, a specified VLAN, or a specified port
interface.
show fip-snooping system
Displays information on the status of FIP snooping
on the switch (enabled or disabled), including the
number of FCoE VLANs, FCFs, ENodes, and
currently active sessions.
show fip-snooping vlan
Displays information on the FCoE VLANs on which
FIP snooping is enabled.
NOTE: The show fip-snooping fcf command may continue to display FCFs the S5000 Fibre
Channel ports advertise even if the ports are shut down because the FIP snooping feature does not
interpret the A-bit in the FIP VLAN advertisements. When you configure the S5000 as an NPIV proxy
gateway, use the
show interfaces status command to check if the S5000 Fibre Channel ports
connected to the FCF are up or down.
366
FCoE Transit