Reference Guide

Command Output
To clear ETS TLV counters, enter the clear ets
counters interface port-type slot/port
command.
show interface port-type slot/port DCBx
detail
Plays the DCBx configuration on an interface.
show stack-unit {0-11 | all} stack
ports all pfc details
Displays the PFC configuration applied to ingress
traffic, including priorities and link delay.
show stack-unit {0-11 | all} stack
ports all ets details
Displays the ETS configuration applied to ingress
traffic on stack-links, including priorities and link
delay.
Examples of the show Commands
The following example shows the show dot1p-queue mapping command.
Dell(conf)# show dot1p-queue-mapping
Dot1p Priority: 0 1 2 3 4 5 6 7
Queue : 0 0 0 1 2 3 3 3
The following example shows the show dcb command.
Dell# show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
The following example shows the show qos priority-groups command.
Dell#show qos priority-groups
priority-group ipc
priority-list 4
set-pgid 2
The following example shows the output of the show qos dcb-map test command.
Dell#show qos dcb-map test
-----------------------
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3 4
The following example shows the show interfaces pfc summary command.
Dell# show interfaces tengigabitethernet 1/4 pfc summary
Interface TenGigabitEthernet 1/4
Admin mode is on
Admin is enabled
Remote is enabled, Priority list is 4
Remote Willing Status is enabled
Data Center Bridging (DCB)
299