Reference Guide

iscsiOptAcl : 0
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl : 4
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
FcoeAcl : 2
iscsiOptAcl : 0
Dell#
Displaying CAM-ACL-Egress Settings
To display the current CAM ACL settings for each egress region, use the show cam-acl-egress
command on the S5000.
The default egress CAM ACL allocation settings on an S5000 (stack unit 0) are in the following example.
Example of CAM-ACL-Egress Settings
Dell#show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
Dell#
CAM Optimization
To optimize CAM utilization for QoS entries by minimizing the required policy-map CAM space, use the
cam-optimization command.
If you apply a policy map containing classification rules (ACL and/or DSCP/IP-precedence rules) to more
than one physical interface on the same port-pipe, only a single copy of the policy is written (only one FP
entry is used).
To disable CAM optimization, use the no cam-optimization command. CAM allocation then behaves
as described in
CAM Allocation.
Content Addressable Memory (CAM)
261