Reference Guide

set next-hop ip-address
Changing the WEIGHT Attribute
To change how the WEIGHT attribute is used, enter the first command. You can also use route maps to
change this and other BGP attributes. For example, you can include the second command in a route map
to specify the next hop address.
• Assign a weight to the neighbor connection.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} weight weight
– weight: the range is from 0 to 65535.
The default is 0.
• Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
– weight: the range is from 0 to 65535.
To view BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode
or the show running-config bgp command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 16
parallel paths to a destination.
NOTE: Dell Networking recommends not using multipath and add path simultaneously in a route
reflector.
To allow more than one path, use the following command.
The show ip bgp network command includes multipath information for that network.
• Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
maximum-paths {ebgp | ibgp} number
The number range is from 1 to 16.
The default is 1.
Filtering BGP Routes Using Route Maps
To filter routes using a route map, use these commands.
1. Create a route map and assign it a name.
CONFIGURATION mode
Border Gateway Protocol IPv4 (BGPv4)
223