Administrator Guide

• Adding a group of ports to a range of VLANs sends multiple messages to the rapid spanning tree protocol (RSTP) task, avoid using the
range command. When using the range command, Dell Networking recommends limiting the range to ve ports and 40 VLANs.
RSTP and VLT
Virtual link trunking (VLT) provides loop-free redundant topologies and does not require RSTP.
RSTP can cause temporary port state blocking and may cause topology changes after link or node failures. Spanning tree topology changes
are distributed to the entire Layer 2 network, which can cause a network-wide ush of learned media access control (MAC) and address
resolution protocol (ARP) addresses, requiring these addresses to be relearned. However, enabling RSTP can detect potential loops caused
by nonsystem issues such as cabling errors or incorrect congurations. RSTP is useful for potential loop detection but to minimize possible
topology changes after link or node failure, congure it using the following specications.
The following recommendations help you avoid these issues and the associated trac loss caused by using RSTP when you enable VLT on
both VLT peers:
• Congure any ports at the edge of the spanning tree’s operating domain as edge ports, which are directly connected to end stations or
server racks. Ports connected directly to Layer 3-only routers not running STP should have RSTP disabled or be congured as edge
ports.
• Ensure that the primary VLT node is the root bridge and the secondary VLT peer node has the second-best bridge ID in the network. If
the primary VLT peer node fails, the secondary VLT peer node becomes the root bridge, avoiding problems with spanning tree port
state changes that occur when a VLT node fails or recovers.
• Even with this conguration, if the node has non-VLT ports using RSTP that are not congured as edge ports and are connected to
other layer 2 switches, spanning tree topology changes can still be detected after VLT node recovery. To avoid this scenario, ensure
that you congure any non-VLT ports as edge ports or have RSTP disabled.
Conguring Interfaces for Layer 2 Mode
To congure and enable interfaces in Layer 2 mode, use the following commands.
All interfaces on all bridges that participate in Rapid Spanning Tree must be in Layer 2 and enabled.
788
Rapid Spanning Tree Protocol (RSTP)