Administrator Guide

To test and display TDR results, use the following commands.
1 To test for cable faults on the TenGigabitEthernet cable.
EXEC Privilege mode
tdr-cable-test tengigabitethernet slot/port
Between two ports, do not start the test on both ends of the cable.
Enable the interface before starting the test.
Enable the port to run the test or the test prints an error message.
2 Displays TDR test results.
EXEC Privilege mode
show tdr tengigabitethernet slot/port
Non Dell-Qualied Transceivers
The system supports Dell-qualied transceivers and only some of the non Dell-qualied transceivers.
If the system displays an error message similar to the following, the transceiver is not Dell-qualied. The Dell Networking OS places the
interface in error-disabled (operationally down) state.
Apr 29 05:09:16: %S4048-ON:1 %IFAGT-2-TRANSCEIVER_UNSUPPORTED_ERROR: Transceiver in slot 1 port
50 unrecognized, putting interface in operational-down state
The following command output displays that the interface is in error-disabled state:
Dell#show interfaces fortyGigE 1/50
fortyGigE 1/50 is up, line protocol is down(error-disabled[Transceiver Unsupported])
Hardware is DellEth, address is 34:17:eb:f2:25:c6
Current address is 34:17:eb:f2:25:c6
Non-qualified pluggable media present, QSFP type is 40GBASE-SR4
Wavelength is 850nm
No power
Interface index is 2103813
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417ebf225c6
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 40000 Mbit
<output truncated for brevity>
For information about which optics and transceivers are supported, contact your Dell representative.
Splitting QSFP Ports to SFP+ Ports
The platform supports splitting a single 40G QSFP port into four 10G SFP+ ports using one of the supported breakout cables (for a list of
supported cables, refer to the Installation Guide or the Release Notes).
NOTE
: When you split a 40G port (such as fo 1/4) into four 10G ports, the 40G interface conguration is still available in the
startup conguration when you save the running conguration by using the write memory command. When a reload of the
system occurs, the 40G interface conguration is not applicable because the 40G ports are split into four 10G ports after the
reload operation. While the reload is in progress, you might see error messages when the conguration le is being loaded. You
can ignore these error messages. Similarly, such error messages are displayed during a reload after you congure the four
individual 10G ports to be stacked as a single 40G port.
To split a single 40G port into four 10G ports, use the following command.
• Split a single 40G port into four 10G ports.
Interfaces
415