Administrator Guide

The following example shows the no stack-unit port-group portmode ethernet command.
Dell(conf)#no stack-unit 0 port-group 0 portmode ethernet
Changing port mode on slot 0 port-group 0 will make interface configs of 0 and 1 obsolete after
a save and
reload.
[confirm yes/no]:yes
Please save and reload for the changes to take effect.
Dell(conf)#
Displaying Fibre Channel Port Group Mode
Information
To display the Fibre Channel Port-Group mode information, use the following show command.
Example of the show system stack-unit Command
Dell#show system stack-unit 0 port-group portmode
PortGroupId Ports Mode(Curr Boot) Mode(Next Boot)
0 0,1 FC FC
1 2,3 FC FC
2 4,5 ETH FC
3 6,7 FC ETH
4 8,9 FC FC
5 10,11 FC FC
Dell#
342
Fibre Channel Interface