Administrator Guide

Example of the show config Command
Dell(conf)#Dell(conf-fmap-default_full_fabric-fcfabric)#show config
domain-id 3
principal-priority 253
E-D-TOV 101
R-A-TOV 10001
R-T-TOV 101
default-zone-allow all
active-zoneset zs1
Dell(conf-fmap-default_full_fabric-fcfabric)#
Example of the show fcoe-map Command
Dell#show fcoe-map
Fabric Name default_full_fabric
Fabric Type full-fabric
Fabric Id 1002
Vlan Id 1002
Vlan priority 3
FC-MAP 0efc00
FKA-ADV-Period 8
Fcf Priority 128
Config-State ACTIVE
Oper-State UP
=======================================
Switch Config Parameters
========================================
R_A_TOV (ms) 10001
R_T_TOV (ms) 101
E_D_TOV (ms) 101
DomainID 3
DomainID-Locked OFF
Principal-Pri 253
=========================================
Switch Zoning Parameters
=========================================
Default Zone Mode: Allow
Active Zoneset: zs1
=======================================================
Members
Fc 0/0 Fc 0/1 Fc 0/2 Fc 0/3 Fc 0/4 Fc 0/5 Fc 0/6 Fc 0/7 Fc 0/8 Fc 0/9 Fc 0/10 Fc 0/11
=======================================================
=======================================================
Dell#
Example of the show fc fabric Command
Dell#show fc fabric
Number of FC Switches = 2
Domain Id Switch WWN Switch Name Mgmt IP addr
1* 10:00:5c:f9:dd:ef:0a:00 Sonoma 127.10.11.11
2 10:00:5c:f9:dd:ef:0a:80 Sonoma 127.10.11.11
Dell#
NOTE
: Domain ID implies this switch is the principal switch.
Example of the show fc Isdb Command
Dell#show fc lsdb
Total number of Link State Data Base Entries = 3
Switch Name 10:00:5c:f9:dd:ef:0a:00
DomainId 1
Switch Port 1
Hops 1
Cost 125
Age 2
LinkCount 2
NeighborID 3
LocalPort 3
RemotePort 1
312
Fabric Services