Reference Guide

mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject
to the filter.
host ipv6-
address
Enter the keyword host followed by the IPv6 address of the
host in the x:x:x:x::x format. The :: notation specifies
successive hexadecimal fields of zero.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
port for the port parameter.)
port port (OPTIONAL) Enter the application layer port number. Enter
two port numbers if using the range logical operand. The
range is 0 to 65535.
destination
address
Enter the IPv6 address of the network or host to which the
packets are sent in the x:x:x:x::x format followed by the
prefix length in the /x format. The range is /0 to /128. The ::
notation specifies successive hexadecimal fields of zero.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
Defaults Not configured.
Command
Modes
ACCESS-LIST
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale. Added the monitor
option.
Usage
Information
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP
port operators (gt, lt, range) may require more than one entry. The range of
ports is configured in the CAM based on bitmask boundaries; the space required
depends on exactly what ports are included in the range.
998
IPv6 Access Control Lists (IPv6 ACLs)