Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
The following describes the interface command shown in the following
example. This example sets a port as hybrid, makes the port a tagged member of
VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN
of the port. The port now accepts:
• untagged frames and classify them as VLAN 10 frames
• VLAN 20 tagged frames
The following describes the do show interfaces command shown in the
following example. This example shows output with “Hybrid” as the newly added
value for 802.1QTagged. The options for this field are:
• True — port is tagged
• False — port is untagged
• Hybrid — port accepts both tagged and untagged frames
The following describes the interface vlan command shown in the following
example. This example shows unconfiguration of the hybrid port using the no
portmode hybrid command.
NOTE: Remove all other configurations on the port before you can remove
the hybrid configuration from the port.
Example
Dell(conf)#interface gi 7/0
Dell(conf-if-gi-7/0)#portmode hybrid
Dell(conf-if-gi-7/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged gi 7/0
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: GigabitEthernet 7/0
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged gi 7/0
Dell(conf-if-vl-20)#interface gi 7/0
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
show interfaces switchport — displays the configuration of switchport (Layer 2)
interfaces on the switch.
switchport — places the interface in a Layer 2 mode.
814
Interfaces