Reference Guide

pre-Version
6.1.1.0
Introduced on the E-Series.
Example (Single
Range)
This example shows how to define an interface range macro named test. Execute
the show running-config command to display the macro definition.
Dell(config)# define interface-range test
tengigabitethernet0/0-3,
gigabitethernet 5/0-47, gigabitethernet 13/0-89
Dell# show running-config | grep define
define interface-range test tengigabitethernet0/0-3,
gigabitethernet5/0-47,
gigabitethernet 13/0 - 89
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Related
Commands
interface range – configures a range of command (bulk configuration)
interface range macro name – runs an interface range macro.
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
802
Interfaces