Reference Guide

duplex (Management interface)
Configure duplex mode on a management interface whose speed is set to 10/100 Mb/s.
S5000
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to
transmit only in one direction.
full Enter the keyword full to set the physical interface to
transmit in both directions.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies only to management interfaces with speed set to 10/100
Mb/s using the speed command.
NOTE: When you set the speed to 10 or 100 Mbps, you can also execute the
duplex command.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the primary or standby stack-unit).
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig and 40 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on}
Parameters
rx on Enter the keywords rx on to process the received flow
control frames on this port. This is the default value for the
receive side.
rx off Enter the keywords rx off to ignore the received flow
control frames on this port.
tx on Enter the keywords tx on to send control frames from this
port to the connected device when a higher rate of traffic is
received.
788
Interfaces