Reference Guide

Version 7.4.1.0 Introduced on the E-Series.
Example
Dell#clear dampening tegigabitethernet 1/2
Clear dampening counters on TeGi 1/2 [confirm] y
Dell#
Related
Commands
show interfaces dampening — displays interface dampening information.
dampening — configures dampening on an interface.
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
S-Series
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
long | medium |
short
Enter the keyword that matches the cable length to be used
at the selected port:
• short = For 1-meter and 3-meter cable lengths.
• medium = For 5-meter cable length.
• long = For 10-meter and 15-meter cable lengths.
Defaults medium
Command
Modes
INTERFACE
Command
History
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
This command only works on ports that the system recognizes as CX4 ports. The
show interfaces command shown in the Example below describes an attempt
to configure an XFP port in an S25P with the command after inserting a CX4
converter into the port.
NOTE: When using a long CX4 cable between the C-Series and the S-Series,
to avoid errors, configure the cable using the cx4-cable-length short
command only.
NOTE: The 15M CX4 active cable is not supported on the C-Series and S-
series. It is only supported for S2410 with active end on the device.
NOTE: For information about using XFP ports with CX4 cables, refer to your S-
Series hardware guide.
Interfaces
783