Reference Guide

fip-snooping fc-map
Configure the FC-MAP value FIP snooping uses on all VLANs.
Syntax
fip-snooping fc-map fc-map-value
To return the configured FM-MAP value to the default value, use the no fip-
snooping fc-map command.
Parameters
fc-map-value Enter the FC-MAP value FIP snooping uses. The range is
from 0EFC00 to 0EFCFF.
Defaults 0x0EFC00
Command
Modes
• CONFIGURATION
• VLAN INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
fip-snooping max-sessions-per-enodemac
Configure the maximum number of FIP-snooping sessions supported on the switch for an ENode MAC
address.
S5000
Syntax
fip-snooping max-sessions-per-enodemac max-value
To remove the configured number of supported sessions, use the no fip-
snooping max—sessions-per-enodemac command.
Parameters
max-value Enter the maximum number of FIP snooping sessions with
an ENode that are supported on the switch. The range is 1 to
64.
FCoE Transit
707