Reference Guide

Usage
Information
Duplicate commands are silently accepted.
Example
Dell(conf-ext-community-list)#permit regexp 123
Dell(conf-ext-community-list)#
Related
Commands
deny regex — denies a community using a regular expression.
set extcommunity rt
To set Route Origin community attributes in Route Map, use this feature.
Syntax
set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [non-
trans] | IPADDR:NN [non-trans]} [additive]
To delete the Route Origin community, use the no set extcommunity
command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific
extended community number in the format ASN4:NN (4-
byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number
in the format ASN:NNNN (2-byte AS number:4-byte
community value).
IPADDR:NN Enter the IP address specific extended community in the
format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte
community value).
additive (OPTIONAL) Enter the keyword additive to add to the
existing extended community.
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a
non-transitive BGP extended community.
Defaults none
Command
Modes
ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
548
Border Gateway Protocol