Reference Guide

BGP table version is 14, main routing table version 14
7 network entrie(s) and 7 paths using 972 bytes of memory
2 BGP path attribute entrie(s) using 112 bytes of memory
1 BGP AS-PATH entrie(s) using 35 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down
State/Pfx
25.25.25.25 6400 21 9 14 0 0
00:02:04 3
211.1.1.129 640 28 6 0 0 0 00:00:21
Active
FTOS#
BGP Extended Communities (RFC 4360)
BGP Extended Communities, as defined in RFC 4360, is an optional transitive BGP attribute.
BGP Extended Communities provides two major advantages over Standard Communities:
• The range is extended from 4-octet (AA:NN) to 8-octet (Type:Value) to provide enough number
communities.
• Communities are structured using a new “Type” field (1 or 2-octets), allowing you to provide granular
control/filter routing information based on the type of extended communities.
deny
To reject (deny) from the two types of extended communities, route origin (rt) or site-of-origin (soo), use
this feature.
Syntax
deny {rt | soo} {as4 ASN4:NN | ASN:NNNN | IPADDR:NN}
To remove (delete) the rule, use the no deny {rt | soo} {as4 ASN4:NN |
ASN:NNNN | IPADDR:NN} command.
Parameters
rt Enter the keyword rt to designate a Route Origin
community.
soo Enter the keyword soo to designate a Site-of-Origin
community (also known as Route Origin).
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific
extended community number in the format ASN4:NN (4-
byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number
in the format ASN:NNNN (2-byte AS number:4-byte
community value).
542
Border Gateway Protocol