Reference Guide

Usage
Information
When you enter the redistribute isis process-id command without any
other parameters, FTOS redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes. This feature is not supported by an RFC.
This feature is not supported by an RFC.
show ip bgp ipv4 multicast
View the current MBGP routing table for the system.
S5000
Syntax
show ip bgp ipv4 multicast [detail | network [network-mask]
[length]]
Parameters
detail (OPTIONAL) Enter the keyword detail to display BGP
internal information for the IPv4 Multicast address family.
network (OPTIONAL) Enter the network address (in dotted decimal
format) of the BGP network to view information only on that
network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format)
of the BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enable the bgp non-deterministic-med command, the show ip
bgp
command output for a BGP route does not list the INACTIVE reason.
The following describes the show ip bgp ipv4 multicast command shown
the Example below.
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
530
Border Gateway Protocol