Reference Guide

Dell Networking
OS Version
Platform Support
7.8.1.0, MBGP for
IPv4 Multicast Only
S-Series
address family ipv4 multicast (MBGP)
This command changes the context to subsequent address family identifier (SAFI).
Syntax
address family ipv4 multicast
To remove SAFI context, use the no address family ipv4 multicast
command.
Parameters
ipv4 Enter the keyword ipv4 to specify the address family as
IPV4.
multicast Enter the keyword multicast to specify multicast as SAFI.
Defaults IPv4 Unicast
Command
Modes
ROUTER BGP (conf-router_bgp)
Command
History
Version 7.8.1.0 Introduced on the S-Series for MBGP IPv4 Multicast.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
After you execute this command, all subsequent commands apply to this address
family. You can exit from this AFI/SAFI to the IPv4 Unicast (the default) family by
entering exit and returning to the Router BGP context.
aggregate-address
Summarize a range of prefixes to minimize the number of entries in the routing table.
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-
set] [attribute-map map-name] [summary-only] [suppress-map map-
name]
Parameters
ip-address
mask
Enter the IP address and mask of the route to be the
aggregate address. Enter the IP address in dotted decimal
format (A.B.C.D) and mask in /prefix format (/x).
advertise-map
map-name
(OPTIONAL) Enter the keywords advertise-map followed
by the name of a configured route map to set filters for
advertising an aggregate route.
512
Border Gateway Protocol