Reference Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Example
Dell(conf-router_bgp)#show config
!
router bgp 100
network 1.1.11.1/32
network 1.1.12.1/32
network 1.1.13.1/32
neighbor 10.1.1.2 remote-as 200
neighbor 10.1.1.2 no shutdown
show ip bgp
View the current BGP IPv4 routing table for the system.
Syntax
show ip bgp [ipv4 unicast] [network [network-mask] [longer-
prefixes]]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal
format) of the BGP network to view information only on that
network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format)
of the BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
476
Border Gateway Protocol