Reference Guide

neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter 0.0.0.0/0.
mask Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
Syntax
neighbor {ip-address | peer-group-name} timers keepalive
holdtime
To return to the default values, use the no neighbor {ip-address | peer-
group-name} timers command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
Border Gateway Protocol
465