Reference Guide

To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced.
Related
Commands
capture bgp-pdu max-buffer-size — specifies a size for the capture buffer.
show capture bgp-pdu neighbor — displays BGP packet capture information.
clear ip bgp
Reset BGP sessions. The soft parameter (BGP Soft Reconfiguration) clears the policies without resetting
the TCP connection.
Syntax
clear ip bgp * | as-number | ip-address [flap-statistics | soft
[in | out]]
Parameters
* Enter an asterisk ( * ) to reset all BGP sessions.
Border Gateway Protocol
419