Reference Guide

address-family
Enable the IPv4 multicast or the IPv6 address family.
Syntax
address-family [ipv4 {multicast | | ipv6 unicast]
Parameters
ipv4 multicast Enter the keyword ipv4 followed by the keyword
multicast to enable BGPv4 multicast mode.
ipv6 unicast Enter the keyword ipv6 followed by the keyword unicast
to enable BGPv6 mode.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.5.1.0 Introduced
aggregate-address
To minimize the number of entries in the routing table, summarize a range of prefixes.
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-
set] [attribute-map map-name] [summary-only] [suppress-map map-
name]
Parameters
ip-address
mask
Enter the IP address and mask of the route to be the
aggregate address. Enter the IP address in dotted decimal
format (A.B.C.D) and mask in /prefix format (/x).
392
Border Gateway Protocol