Reference Guide

Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up GigabitEthernet 2/1 priority-cost 10
Up GigabitEthernet 12/17 priority-cost 10
Dell>
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
C-Series, E-Series, S-Series (S50)
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For Port Channel interface types, enter the keywords
port-channel followed by the number. For the C-
Series and S-Series, the range is 1 to 128. For the E-Series,
the range is 1 to 255 for TeraScale.
• For SONET interfaces, enter the keyword sonet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed
by the VLAN ID. The VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to be subtracted
from the priority value. The range is 1 to 254. The default is
10.
Defaults priority cost = 10
2024
Virtual Router Redundancy Protocol (VRRP)