Reference Guide

Version 9.5(0.0) Introduced on the Z9500.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
After you configure the VLT domain on each peer switch on both sides of the
interconnect trunk, by default, the Dell Networking OS software elects a primary
and secondary VLT peer device. To reconfigure the primary role of VLT peer
switches, use the priority command.
show vlt brief
Displays summarized status information about VLT domains currently configured on the switch.
Syntax
show vlt brief
Default Not configured.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
The version shown in the show vlt brief output command displays the VLT
version number which is different from the Dell Networking OS version number.
VLT version numbers are begin with odd numbers such as 3 or 5.
Example (Brief)
Dell(conf) #show vlt brief
VLT Domain Brief
----------------------------
Domain ID: 10
Role: Primary
Role Priority: 32768
1998
Virtual Link Trunking (VLT)