Reference Guide

stack-unit stack-group
Configure a stacking group specified by an ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
[no] Use no stack-unit unit-id stack-group stack-id
to remove the current stack group configuration.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.10.2
Introduced on the S4810.
Usage
Information
WARNING: The following message displays to confirm the command: All
non-default configurations on the related member ports
ports (<ports listed here>) will be removed. Do you want to
continue (y/n)? If you enter “y”, all non-default configurations on any
member ports of the current stack group is removed when the unit is
rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
1970
VLAN Stacking