Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Related
Commands
• reload – reboots Dell Networking OS.
• show system (S-Series and Z-Series) – displays the status of all stack members
or a specific member.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-11 renumber 0-11
Parameters
0-11 The first instance of this value is the stack member unit
identifier, from 0 to 11, of the switch that you want add to
the stack. The range is: 0 to 11. The second instance of this
value is the desired new unit identifier number.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
You can renumber any switch, including the management unit or a stand-alone
unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the
members are renumbered, only that specific unit is reset and comes up with the
new unit number.
Example
Dell#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
• reload – reboots Dell Networking OS.
Stacking Commands
1911