Reference Guide

redundancy force-failover stack-unit
Force the standby unit in the stack to become the management unit.
Syntax
redundancy force-failover stack-unit
Parameters
stack-unit Enter the stack unit.
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the members option.
Version 7.7.1.0 Introduced on the S-Series.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax
reset stack-unit hard
Parameters
stack-unit Enter the stack-unit number.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
1904
Stacking Commands