Reference Guide

show config
Display the current configuration for the mode. Only non-default values display.
Syntax
show config
Command
Modes
SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group configuration and status of interfaces in the spanning tree group.
Syntax
show spanning-tree 0 [active | brief | guard | interface
interface | root | summary]
Parameters
0 Enter 0 (zero) to display information about that specific
spanning tree group.
active (OPTIONAL) Enter the keyword active to display only active
interfaces in spanning tree group 0.
1896
Spanning Tree Protocol (STP)