Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type
] [notification-option] command.
Parameters
notification-
type
Enter the type of notification from the following list:
• bgp — Notification of changes in the BGP process.
• config — Notification of changes to the startup or
running configuration.
• ecfm — Notification of changes to ECFM.
• ecmp — Enable an ECMP trap to notify of ECMP or link
bundle traffic imbalances.
• envmon — For Dell Networking device notifications when
an environmental threshold is exceeded.
• isis — Notification of intermediate service traps.
• lacp — Notification of changes.
• snmp — Notification of RFC 1157 traps.
Simple Network Management Protocol (SNMP) and Syslog
1849