Reference Guide

Usage
Information
To access this command, enter the class-map command. You can match against
only one VLAN ID.
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Enter the name of the policy map in character format (32
characters maximum).
Defaults none
Command
Modes
CONFIGURATION (policy-map-input and policy-map-output)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
If the rate shape exists in both aggregate and per-queue qos-policy, minimum of 2
take effect. Some of all Queue-rate will not exceed aggregate.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
1624
Quality of Service (QoS)