Reference Guide

show ipv6 pim tib
View the IPv6 PIM multicast-routing database (tree information base — tib).
Syntax
show ipv6 pim tib [group-address [source-address]]
Parameters
group-address (OPTIONAL) Enter the multicast group address in the
x:x:x:x::x format to view RP mappings for a specific group.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
source-address (OPTIONAL) Enter the source address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0(1.3) Introduced on the S5000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.4.1.0 Introduced
Example
Dell#show ipv6 pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P -
Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J -
Join SPT,
M - MSDP created entry, A - Candidate for MSDP
Advertisement
K - Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(25::1, ff0e::225:1:2:1), uptime 00:09:53, expires
00:00:00,flags: CJ
RPF neighbor: TenGigabitEthernet 1/3,
fe80::201:e8ff:fe00:6265
1576
PIM-Sparse Mode (PIM-SM)