Reference Guide

ipv6 pim neighbor-filter
Prevent the system from forming a PIM adjacency with a neighboring system.
Syntax
ipv6 pim neighbor-filter {access-list}
Parameters
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.1.0 Introduced
Usage
Information
Do not enter this command before creating the access-list.
ipv6 pim register-filter
Configure the source DR so that it does not send register packets to the RP for the specified sources and
groups.
Syntax
ipv6 pim register-filter access-list
Parameters
access-list Enter the name of the extended ACL that contains the
sources and groups to filter.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1568
PIM-Sparse Mode (PIM-SM)