Reference Guide

Version
8.3.12.0
Introduced on the S4810.
Version 7.3.1.0 Introduced
Example
Dell(conf)#ipv6 access-list JOIN-FIL_ACL
Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
Dell(conf-ipv6-acl)#exit
Dell(conf)#interface tengigabitethernet 0/84
Dell(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
Dell(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router
query messages. The range is from 0 to 65535. The default is
30 seconds.
Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.4.1.0 Introduced
PIM-Sparse Mode (PIM-SM)
1567