Reference Guide

IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
clear ipv6 pim tib
Clear the IPv6 PIM multicast-routing database (tree information base—TIB).
Syntax
clear ipv6 pim tib [group-address]
Parameters
group-address (OPTIONAL) Enter the multicast group address in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version
8.3.12.0
Introduced on the S4810.
Version 7.4.1.0 Introduced
Related
Commands
show ipv6 pim tib – displays the IPv6 PIM tree information base (TIB)
debug ipv6 pim
Invoke IPv6 PIM debugging.
Syntax
debug ipv6 pim [bsr | events | group group | packet | register
[group] | state | | timer [assert | hello | joinprune |
register]]
To disable IPv6 PIM debugging, use the no debug ipv6 pim command.
Parameters
bsr (OPTIONAL) Enter the keyword bsr to invoke debugging of
IPv6 PIM Candidate RP/BSR activities.
events (OPTIONAL) Enter the keyword events to invoke debugging
of IPv6 PIM events.
group group (OPTIONAL) Enter the keyword group followed by the group
address to invoke debugging on that specific group.
1562
PIM-Sparse Mode (PIM-SM)