Reference Guide

host ip-address Enter the keyword host then the IP address to specify a host
IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Defaults none
Command
Modes
REDIRECT-LIST
Command
History
Version 8.4.2.1 Introduced on the C-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Syntax
seq sequence-number {permit | redirect {ip-address}} {ip-
protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit]
[operator]{source-port source-port| source-port-range start-
port - end-port} {destination-port destination-port|
destination-port-range start-port - end-port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
1526
Policy-based Routing (PBR)