Reference Guide

• Dead timer remaining value for each neighbor
• Transmit timer remaining value for each neighbor
• The LSU Q length and its highest mark for each neighbor
• The LSR Q length and its highest mark for each neighbor
Example
(Statistics)
Dell(conf-if-te-0/6)#do show ip ospf statistics
Interface TenGigabitEthernet 0/6
Error packets (Receive statistics)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unknown-Pkt 0 Bad-LsReq 0
RtidZero 0
Neighbor ID 4.4.4.4
Packet Statistics
Hello DDiscr LSReq LSUpd LSAck
RX 5 2 1 3 2
TX 6 5 1 3 3
Timers
Hello 0 Wait 0 Grace 0
Dead 39 Transmit 4
Queue Statistics
LSU-Q-Len 0 LSU-Q-Wmark 1
LSR-Q-Len 0 LSR-Q-Wmark 1
Dell(conf-if-te-0/6)#
Related
Commands
clear ip ospf statistics — clears the packet statistics in all interfaces and neighbors.
show ip ospf timers rate-limit
Show the LSA currently in the queue waiting for timers to expire.
Syntax
show ip ospf [process-id] timers rate-limit
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
1480
Open Shortest Path First (OSPFv2 and OSPFv3)