Reference Guide

passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf [process-id]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added output for LSA throttling timers.
Version 8.3.7.0 Introduced on the S4810.
Version 7.9.1.0 Added support for VRF.
Version 7.8.1.0 Added support of Multi-Process OSPF.
Version 7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf
command output does not list Area 0.
Open Shortest Path First (OSPFv2 and OSPFv3)
1449