Reference Guide

• All previous no passive-interface interface commands are removed
from the running configuration.
no passive-interface interface
• Remove the interface from the passive list.
• The ABR status for the router is updated.
• If passive-interface default is specified, then save no passive-
interface
interface into the running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
On configuring suppression using the passive-interface command, the state of the
OSPF neighbor does not change to INIT; instead, the state of the OSPF neighbor
changes to DOWN after the dead-timer expires.
debug ip ospf
Display debug information on OSPF. Entering the debug ip ospf commands enables OSPF debugging
for the first OSPF process.
S5000
Syntax
debug ip ospf process-id [bfd |event | packet | spf | database-
timer rate-limit]
To cancel the debug command, use the no debug ip ospf command.
Parameters
process-id Enter the OSPF Process ID to clear a specific process. If no
Process ID is entered, all OSPF processes are cleared.
bfd (OPTIONAL) Enter the keyword bfd to debug only OSPF BFD
information.
event (OPTIONAL) Enter the keyword event to debug only OSPF
event information.
packet (OPTIONAL) Enter the keyword packet to debug only OSPF
packet information.
spf (OPTIONAL) Enter the keyword spf to display the Shortest
Path First information.
database-timer
rate-limit
(OPTIONAL) Enter the keywords database-timer rate-
limit to display the LSA throttling timer information.
Open Shortest Path First (OSPFv2 and OSPFv3)
1441