Reference Guide

• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Not configured.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
rip | static]
To remove a filter, use the no distribute-list prefix-list-name out
[bgp | connected | isis | rip | static]
command.
Parameters
prefix-list-
name
Enter the name of a configured prefix list.
bgp (OPTIONAL) Enter the keyword bgp to specify that BGP
routes are distributed.
1418
Open Shortest Path First (OSPFv2 and OSPFv3)