Reference Guide

no-summary (OPTIONAL) Enter the keywords no-summary to prevent the
ABR from sending summary Link State Advertisements (LSAs)
into the stub area.
Defaults Disabled.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To configure all routers and access servers within a stub, use this command.
Related
Commands
router ospf — enters ROUTER OSPF mode to configure an OSPF instance.
area virtual-link
Set a virtual link and its parameters.
C-Series, E-Series, S-Series
Syntax
area area-id virtual-link router-id [[authentication-key
[encryption-type] key] | [message-digest-key keyid md5
[encryption-type] key]] [dead-interval seconds] [hello-interval
seconds] [retransmit-interval seconds] [transmit-delay seconds]
To delete a virtual link, use the no area area-id virtual-link router-id
command.
To delete a parameter of a virtual link, use the no area area-id virtual-link
router-id [[authentication-key [encryption-type] key] |
Open Shortest Path First (OSPFv2 and OSPFv3)
1405