Reference Guide

Multicast

The multicast commands are supported by Dell Networking operating system (OS) on all platform.

This chapter contains the following sections:

• IPv4 Multicast Commands

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent

multicast (PIM) tree information base, use the

clear ip pim tib command.

Syntax

clear ip mroute {group-address [source-address] | * | snooping}

Parameters

group-address

[source-

address]

Enter the multicast group address and source address (if

desired), in dotted decimal format, to clear information on a

specific group.

* Enter * to clear all multicast routes.

snooping Enter the keyword snooping to delete multicast snooping

route table entries.

Command

Modes

EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2.

(0.0)

Added support for keyword snooping on the Z9000, S4810,

and S4820T.

Multicast

1367