Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Introduced on the S4810.
Legacy E-
Series
command.
Usage
Information
If you enter only the fefd-global syntax, the mode is normal and the default
interval is 15 seconds.
If you disable FEFD globally (no fefd-global), the system does not remove the
FEFD interface configuration.
Related
Commands
• fefd — enables far-end failure detection.
• fefd-global interval — configures an interval between FEFD control packets.
• show fefd — shows the FEFD command output.
fefd-global interval
Configure an interval between FEFD control packets.
Syntax
fefd-global interval seconds
To return to the default value, use the no fefd-global interval command.
Parameters
seconds Enter a number as the time between FEFD control packets.
The range is from 3 to 300 seconds. The default is 15
seconds.
Defaults 15 seconds
Command
Modes
CONFIGURATION
Layer 2
1293