Reference Guide

Example
(Address-
Family_IPv6)
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
FTOS(conf-router_isis-af_ipv6)#show conf
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
Display the IS-IS link state database.
Syntax
show isis database [level-1 | level-2] [local] [detail |
summary] [lspid]
Parameters
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
detail (OPTIONAL) Detailed link-state database information of each
LSP displays when specified. If not specified, a summary
displays.
summary (OPTIONAL) Summary of link-state database information
displays when specified.
lspid (OPTIONAL) Display only the specified LSP.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on the Z9000.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Intermediate System to Intermediate System (IS-IS)
1237