Reference Guide

Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
The hostname is used in the prompt.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on platform.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel followed by a number:
– S-Series: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.1) Introduced on the S4810, S4820T, S6000, and Z9000.
Version 8.3.11.1 Introduced on the Z9000
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
118
Control and Monitoring