Reference Guide

ipv4-neighbor-
addr | ipv6-
neighbor-addr
Clear and reapply policies for a neighbor.
peer-group
name
Clear and reapply policies for all BGP routers in the specified
peer group.
ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option,
both inbound and outbound policies are reset.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
Version 7.8.1.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced on the E-Series TeraScale.
debug ip bgp
Allows you to view all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] [in |
out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
IPv6 Border Gateway Protocol (IPv6 BGP)
1069