Reference Guide

Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, the
names are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Example
Dell(conf)#route-map Rmap1
Dell(config-route-map)#match ?
…
ip IP specific information
ipv6 IPv6 specific information
…
Related
Commands
show config – views the current configuration.
set ipv6 next-hop
Configure a filter that specifies IPv6 address as the next hop.
C-Series, E-Series, S-Series
Syntax
set ipv6 next-hop ipv6-address
To delete the setting, use the no set ipv6 next-hop ipv6-address
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
1014
IPv6 Access Control Lists (IPv6 ACLs)