Reference Guide

match ipv6 route-source
Configure a filter which matches based on the routes advertised in the IPv6 prefix lists.
C-Series, E-Series, S-Series
Syntax
match ipv6 route-source prefix-list prefix-list-name
To delete a match, use the no match ipv6 route-source prefix-list
prefix-list-name command.
Parameters
prefix-list
prefix-list-
name
Enter the keywords prefix-list followed by the name of
configured prefix list, up to 140 characters.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, the
names are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
match ipv6 address – redistributes routes that match an IP address.
match ipv6 next-hop – redistributes routes that match the next-hop IP address.
route-map
Designate a IPv6 route map name and enter ROUTE-MAP mode.
C-Series, E-Series, S-Series
Syntax
route-map map-name
To delete a route map, use the no route-map map-name command.
Parameters
map-name Enter a text string to name the route map, up to 140
characters.
IPv6 Access Control Lists (IPv6 ACLs)
1013